Yetter 2987 NH3 Magnum User Manual

2987 NH3 MAGNUM 2565-758_REV_I • 04/2014 YETTER MANUFACTURING CO. FOUNDED 1930 Colchester, IL

10 ASSEMBLY INSTRUCTIONS Step 3. Attach the closing wheel assembly to the arm, use 3 washers, lock washer and hex nut. I800-00

11 TOOLBAR FRAME HEIGHT ADJUSTMENT Figure A. The toolbar frames are equally 26”-28” off the ground.

12 OPERATION INSTRUCTIONS RIGHT HAND ASSEMBLY DIRECTION OF TRAVEL 1. Adjust the shoe the same front and back. 2. Start with no gap between the b

13

14 MAINTENANCE Lubrication Symbols Lubricate with grease at hourly interval indicated on symbol. Lubrication Intervals IMPORTANT: The re

15 MAINTENANCE Lubrication CAUTION: To help prevent serious injury or death to you or others caused by unexpected movement, service machine on a le

16 MAINTENANCE Storing the Equipment Store the machine in an area away from human activity Store machine in RAISED position. Install service lock

17 OPERATION MAINTENANCE BEARING ADJUSTMENT: 1. Raise the toolbar until the blade is clear of the ground. Place a safety stan

18 PARTS IDENTIFICATION

19 PARTS IDENTIFICATION KEY QTY. PART NUMBER DESCRIPTION 1 1 2550-065 HUB CAP, WILTON #909912-1 2 1 2986-

2

20 PARTS IDENTIFICATION

21 PARTS IDENTIFICATION

22 PARTS IDENTIFICATION

23 PARTS IDENTIFICATION

24 PARTS IDENTIFICATION

25 PARTS IDENTIFICATION

26 PARTS IDENTIFICATION

27 PARTS IDENTIFICATION

28 PARTS IDENTIFICATION

29 PARTS IDENTIFICATION

3

30 PARTS IDENTIFICATION

31 PARTS IDENTIFICATION

32 PARTS IDENTIFICATION

33 PARTS IDENTIFICATION

34 PARTS IDENTIFICATION

35 NOTES

36 Our name Is getting known Just a few years ago, Yetter products were sold primarily to the Midwest only. Then we embarked on a p

4

5

6

7ASSEMBLY INSTRUCTIONS The 2987 NH3 Magnum coulter is designed to mount to rectangular toolbars in three sizes: 5” x 7”, 6” x 6”or 7” x 7”. WARNI

8 ASSEMBLY INSTRUCTIONS Step 1. Install the ½” x 2 ½” bolt, washer, bushing and lock nut to the closing wheel arm. I800-0

9 ASSEMBLY INSTRUCTIONS Step 2. Attach the closing wheel arm and the torsion spring to the knife mount, install the cotter pin and washer. KNIFE