Yetter 2967-007 U.N.T. Residue Manager User Manual

TITAN SERIES 2960 U.N.T. COULTER 2967-007 U.N.T. RESIDUE MANAGER OPERATOR’S MANUAL 2565-692_REV_F 12/2011

10 INSTALLATION INSTRUCTIONS STEP 7. Attach the blade to the coulter arm assembly using the 4) ½” x 1-1/4” carriage bolts, lock washers and hex n

11 INSTALLATION INSTRUCTIONS STEP 8. Choose the mounting hole in which to attach the residue manage wheels. Both wheels mounted in the front holes

12 OPERATION 1. Set/mount coulter blades to run perpendicular to the soil. Operation depth and blade wear can be affected if the coult

13 OPERATION CAUTION: Where rocks are present the residue manager should be set in the “float” position, not locked down. Adjust the residue manag

14 MAINTENANCE BEARING ASSEMBLY AND LUBRICATION Practice Safety Understand and practice safe service procedures before doing work. Follow ALL t

15 MAINTENANCE NOTE: Be certain to align the grease fitting with the slot in the wheel and the hubcap so that the grease can flow freely.

16 MAINTENANCE Grease must fill this Hubcap cavity.

17 MAINTENANCE Lubrication CAUTION: To help prevent serious injury or death to you or others caused by unexpected movement, service machine on a lev

18 MAINTENANCE Lubrication Symbols Lubricate with grease at hourly interval indicated on symbol. Lubrication Intervals IMPORTANT: The recommen

19 MAINTENANCE Storing the Equipment Store the machine in an area away from human activity Store machine in RAISED position. Install service loc

2 FOREWORD You’ve just joined an exclusive but rapidly growing club. For our part, we want to welcome you to the group and thank yo

20 PARTS IDENTIFICATION

21 PARTS IDENTIFICATION

22 PARTS IDENTIFICATION 15˾ UNT RESIDUE MANAGER KIT

23 PARTS IDENTIFICATION

24 TROUBLESHOOTING Problem Cannot adjust coulter depth shallow enough. Cannot adjust coulter deep enough. Coulter will not penetrate.

25 OPERATION PRECAUTIONS STOP Read this before using the Yetter product. - MACHINE OPERATION IMPORTANT: failure to properly set the planter fram

26 PLANTER HEIGHT ADJUSTMENT Figure A. – The planter hitch and frame are both 20” off the ground. To ensure this, visually check to see that the

27 NOTES

28 Our name Is getting known Just a few years ago, Yetter products were sold primarily to the Midwest only. Then we embarked on a progr

3 SAFETY PRECAUTIONS A brief description of signal words that may be used in this manual: CAUTION: Used as a general reminder of good safety pr

4 INTRODUCTION The 2960 U.N.T. Unit Mounted Conservation Coulter has been designed as a ‘universal’ fitment for several makes of planter units. By

5 BOLT TORQUE Mounting bolts and hardware Before operating the Titan Residue Manager for the first time, check to be sure that all hardware is t

6 INSTALLATION INSTRUCTIONS 15" PLANTER BLADES 15" PLANTER BLADES JD 7000 AND KINZE PLANTERS JD 1700, 7200 AND 7300 PLANTER

7 INSTALLATION INSTRUCTIONS STEP 1. Attach the coulter bracket to the planter unit using (3) ½” x 1-1/2” bolts and lock nuts. Do no fully tighten

8 INSTALLATION INSTRUCTIONS NOTE: For models with residue managers go to STEP 4. STEP 3. For coulter only models, Attach the blade to the coulter

9 INSTALLATION INSTRUCTIONS STEP 5. Attach the residue manager assembly to the coulter bracket using the 5/8” x 2-1/4” bolt, 6000-335 bushing, 2527