Yetter 2967-002 Single Wheel Residue Manager for Twin row User Manual

2967-002 SINGLE ARM RESIDUE MANAGER FOR TWIN ROW PLANTER OPERATOR’S MANUAL PART IDENTIFICATION 2565-763_REV_A – 12/11

10 MAINTENANCE Regularly inspect the residue manager for loose or worn parts. Repair and replace as needed. BEARING ASSEMBLY AND LUBRICATION Pra

11 MAINTENANCE NOTE: Be certain to align the grease fitting with the slot in the wheel and the hubcap so that the grease can flow freely.

12 MAINTENANCE Grease must fill this Hubcap cavity.

13 MAINTENANCE Lubrication CAUTION: To help prevent serious injury or death to you or others caused by unexpected movement, service machine on

14 MAINTENANCE Lubrication Symbols Lubricate with grease at hourly interval indicated on symbol. Lubrication Intervals IMPORTANT: The re

15 MAINTENANCE Storing the Equipment Store the machine in an area away from human activity Store machine in RAISED position. Install service loc

16 PARTS IDENTIFICATION 2967-002-R-ST-FW (SHOWN)

17 PARTS IDENTIFICATION (SHOWN)

18 Our name Is getting known Just a few years ago, Yetter products were s

2 FOREWORD You’ve just joined an exclusive but rapidly growing club. For our part, we want to welcome you to the group and thank yo

3 TABLE OF CONTENTS Introduction……………………………………………………………….……2 Warranty……………………………….……………………………………...2 Table of Contents……………………………………………………………..3 Op

4 BOLT TORQUE Mounting bolts and hardware Before operating the Residue Manager for the first time, check to be sure that all hardware is tight.

5 OPERATION ROW CLEANER DO’S AND DON’TS 1. DO NOT move soil; Residue Managers are designed to move crop residue only. 2. DO NOT operate planter at

6 OPERATION PRECAUTIONS STOP Read this before using the Yetter product. - MACHINE OPERATION IMPORTANT: failure to properly set the planter frame

7 PLANTER ADJUSTMENT

8 INSTALLATION INSTRUCTIONS STEP 1. Attach the Residue Manager to the planter unit using 4) ½” bolts, nuts, and lockwashers.

9 INSTALLATION INSTRUCTIONS STEP 2. Attach the R.M. wheel/hub assembly to the arm using 5/8” lock washer and hex nut. Adjust the bearing shiel