2967-047 TITAN RESIDUE MANAGER FOR JOHN DEERE HD COULTER OPERATOR’S MANUAL PART IDENTIFICATION YETTER MANUF
10MAINTENANCE BEARING ASSEMBLY AND LUBRICATION Practice Safety Understand and practice safe service procedures before doing work. Follow ALL the
11MAINTENANCE NOTE: Be certain to align the grease fitting with the slot in the wheel and the hubcap so that the grease can flow freely. IMPORTANT
12MAINTENANCE Grease must fill this Hubcap cavity.
13MAINTENANCE Lubrication CAUTION: To help prevent serious injury or death to you or others caused by unexpected movement, service machine on a lev
14MAINTENANCE Lubrication Symbols Lubricate with grease at hourly interval indicated on symbol. Lubrication Intervals IMPORTANT: The recommended
15MAINTENANCE Storing the Equipment Store the machine in an area away from human activity Store machine in RAISED position. Install service locks
16PARTS IDENTIFICATION
17NOTES
18NOTES
19NOTES
2FOREWORD You’ve just joined an exclusive but rapidly growing club. For our part, we want to welcome you to the group and thank you for buying a Ye
20 Our name Is getting known Just a few years ago, Yetter products were sold primarily to the Midwest only. Then we embarked on a program of e
3SAFETY A brief description of signal words that may be used in this manual: CAUTION: Used as a general reminder of good safety practices or to dir
4TABLE OF CONTENTS Introduction…………………………………………………………..pg. 2 Warranty……………………………….……………………………..pg. 2 Safety Information…………………………………………………...pg. 2-3
62967-047 – TITAN FOR JOHN DEERE COULTER INSTALLATION INSTRUCTIONS STEP 1. Install the 2966-203 and 2967-614 to the coulter using the ½” x 2” b
7INSTALLATION INSTRUCTIONS STEP 2. Attach the 2967-616 support plate to the adjustment bracket using the ½” x 2” bolt and 2967-622 spacer. Do not
8INSTALLATION INSTRUCTIONS STEP 4. Attach the residue manager arm/wheel assembly using the 5/8” x 2” bolt, bushing and 5/8” x 3” bolt, washer, bush
9 OPERATION CAUTION: Where rocks are present the residue manager should be set in the “float” position, not locked down. STEP 1. Adjust the resi
Comments to this Manuals