2967-042 TITAN RESIDUE MANAGER FOR JOHN DEERE HD COULTER OPERATOR’S MANUAL PART IDENTIFICATION 2565-754_REV_D ● 07/13
10 MAINTENANCE NOTE: Be certain to align the grease fitting with the slot in the wheel and the hubcap so that the grease can flow freely.
11 MAINTENANCE Grease must fill this Hubcap cavity.
12 MAINTENANCE Lubrication CAUTION: To help prevent serious injury or death to you or others caused by unexpected movement, service machine on a le
13 MAINTENANCE Lubrication Symbols Lubricate with grease at hourly interval indicated on symbol. Lubrication Intervals IMPORTANT: The recommended
14 MAINTENANCE Storing the Equipment Store the machine in an area away from human activity Store machine in RAISED position. Install service locks
15 PARTS IDENTIFICATION
16 Our name Is getting known Just a few years ago, Yetter products were sold primarily to the Midwest only. Then we embarked on a program of exp
2FOREWORD You’ve just joined an exclusive but rapidly growing club. For our part, we want to welcome you to the group and thank you
3SAFETY A brief description of signal words that may be used in this manual: CAUTION: Used as a general reminder of good safety practices or to dir
4TABLE OF CONTENTS Introduction………………………………………………………….. 2 Warranty……………………………….…………………………….. 2 Safety Information…………………………………………………... 2-3 Table o
5
62967-042 – TITAN FOR JOHN DEERE COULTER INSTALLATION INSTRUCTIONS STEP 1. Install the 2966-170 mount bracket and the JD coulter using the M1
7 INSTALLATION INSTRUCTIONS STEP 2. Attach the residue manager arm/wheel assembly using the M16 X 45 Hex Flange Screw, bushing, and locknuts. Do n
8OPERATION CAUTION: Where rocks are present the residue manager should be set in the “float” position, not locked down. STEP 1. Adjust the residu
9MAINTENANCE BEARING ASSEMBLY AND LUBRICATION Practice Safety Understand and practice safe service procedures before doing work. Follow ALL the o
Comments to this Manuals